2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
Status
Not open for further replies.

Firmware update

6 reading
83K views 62 replies 23 participants last post by  ASH8  
@Tristan-cx5
So, in the 2nd post of this thread, when you say "Updates of the firmware do not bring along new features".. does that mean if I currently have 55.00.753 NA (fail safe is also .753), which has a 7in (I think) screen BUT NOT TOUCH.. then no upgrade I do would enable that screen to BECOME TOUCH?

I'm sorry, I'm obviously new.. and i know this topic is all over the place, literally and metaphorically, here on this board... but damn if it isn't hard to gather it all together.

I just wanna know if it's possible for me to update my system to have TOUCH.. amd that mute/pause would be nice.. and play videos on my screen... those 3 are basically all I'd need..
Is there a specific version I need to upgrade to or whichever is just the newest/newer that I can find? Can I jump straight to the most current version update or would I need to gradually upgrade version by version to get there?
And the easiest way possible... I just wouldn't be able to install new physical hardware.. I can do USB along with computer, etc tho.. just not run new wires or anything like that... unless that's super easy then maybe.

This has been a 2+ year project, on and off.. I keep walking because it gets discouraging... which rhymes with confusing lol
 
@Tristan-cx5
Thank you for replying!

I am the 2nd owner.. however, the 1st owner only put maybe 100-200 miles on it before turning the lease back in... and then I got it soon after.. so I've had the car since Mar 2016. .. only has just under 50k miles.. but anyways..

I do have a couple questions. I don't wanna be too much of an annoyance by asking too many.. I'm a big "researcher", so usually I can take off with what information I do have and find out what I need.. so don't worry, I won't be "that guy" lol..
Also, I've owned the car for so long now I'm embarrassed to say that I dont remember if I've tried touchscreen while not moving.. I prob did when I first got it and have since forgotten.. but I do know I've touched the screen to check one day (prob while driving) and it didn't work, so its been in my mind that I didn't have it.. so I will check that out and atleast comment back if it works or not.

As I've said before, Mines 55.00.753 NA.
And if I understand your reply correctly, then because I'm below the 59.00.502, then I'm still capable of using USB downloads?
And if that is the case.. then should my plan be to go back and find that AIO post and download the ID7 first (so that futureproofs me from being blocked out from doing future tweaks once I upgrade past 59.00.502).
Once ID7 is installed, then I pretty much do the same for 70.00.100? (Aslong as that version provides capabilities of mute/pause and video playback, which I'm assuming will). If this is all correct then I should be good to go with figuring it out.

I dont think I necessarily need that absolute newest version. Granted idk the difference between all the different versions, which is something I can look into and find out if it's something I might wanna go ahead and do.
I dont use Navigation at all..
I just need my bluetooth and to improve to having mute/pause and video play.

If there's any information that you think is important to me in regards to this please lmk. Like something to watch out for or something like that.

Thanks again!
 
@Tristan-cx5
Awesome! That's exactly what I needed to know.. thanks again!!

And my car does NOT have working touch..
Not in Park, nor in gear with foot on the brake (AT), nor obviously driving. So I'll have to check into that more, via SSPB6.
Bummer, but I can live without.. I'd just be happy with just getting the pause/mute and video play.

Edit: you are correct.. a quick Google search says my car is to have touchscreen.

Edit #2: Once I upgrade to or past 59.00.502 will I then lose the ability to USB tweak? (Meaning once mg system is v59+ have to serial connect for the next updated tweaks).. Or since I'm originally v55, I'll always have that ability to USB no matter what?
I think the ID7, aka Auto Run, is what will allow me to always be able to just use USB without having the need to serial port.. correct?

Ps: I'm sorry
 
@Tristan-cx5

Sorry, disrega this post, ive fpund the solution.. but ill keep this up to help others.. solution is to click tweak that says "skip confirmation".

I'm having a serious issue trying to install ID7 without having touch screen. My dial (which normally works) is not an option to work to click INSTALL. Not a single thing happens when I go click and twisting buttons, except for move and click in the background (like apps/entertainment/settings/radio, etc).. its just ignoring the "Tweaks Selection for Autorun" screen.

I also just tried a 2nd USB with actual tweaks on it.. ans it's the same issue.. I can read the screen and see that I need to click "YES-GO ON", but my dial won't highlight to click it.

I've tried all the turning and clicking variation I can do.. except for holding down certain buttons or other cheat codes

Is it possible that if I sit here long enough, either ID7 or the other USB woth the tweaks will move forward on its own?
 
@Tristan-cx5
Hey, I'm a bit confused. I tried researching it but I haven't found a clear enough post for the answer.
But what is the highest FW I can go up to that would be the last FW that's USB only capable? (USB: meaning for USB downloaded aio tweaks)
Like, is 59.00.502 the last FW that still allows me to use USB? Or would it be the V before. 502? .. like .100 I think it was.

"From 59.00.502-70.00.100 you can enable the system to install tweaks via usb again via serial access only: www.mazdatweaks.com/serial
If you stay at FW v55 (and do not update to FW 59 or 70), you still have the ability to install AIO tweaks via USB.
I think the ID7, aka Auto Run, is what will allow me to always be able to just use USB without having the need to serial port.. correct? -> correct. from 59.00.502 up to/including 70.00.100.
So this alone may answer my question. But in your "quoted" reply.. are you saying that I can have USB tweaks still be available to me, but only if I first enable that "USB allowed"setting by first using a serial connection within versions 59.00.502-70.00.100.. And then, after serial connection and setting the "USB allowed" setting to allow USB capabilities, then I can now JUST use USB.. (all of this ONLY applies if the FW is between 59.00.502-70.00.100... correct?)

So if that's true, then as long as I stay 59.00.100 (or whichever is the next below .502), then I can just use USB and never have to mess with serial connection.. correct?

As a refresher: I'm currently at 55.00.753 NA Mexico.. I have done ID7.. (is that what SSH is btw?). And I have played around with tweaks.. I currently have Speedometer, Changed Background, NO Disclaimer, Allow Touchscreen while driving (Even tho mine don't work), NO Reverse Canera Warning, Main Menu Loop, Pause on Mute (which only works on Video Player, not Bluetooth audio with my phone playing a movie), and I also have the Video Player.

My next plans are to figure out AA.. if I can set it up and use it without having to get the Hub. I believe I can, by connecting my phone to USB.. (even on my current FW?).
And try to figure out more about the Video Player.. because right now when I play a movie, it starts completely over each time I start up the car.. I want to see if I can have it pick up where I left off. (My touch doesn't work, I'm wondering if it did, if I could just tap the screen and skip ahead to where I left off, because right now I have to twist the knob and skip ahead like 10secs each twist).
And my last little project is to see if I can DIY fix my touchscreen by just replacing the screen or whatever it's going to take. Whether that's just the actual screen itself.. or the whole 7inch tablet. (I just missed SSPB6 by 3 months).
 
@SergSlim
Yes, this is actually what I wanted to know.. thank you very much!!

I really would like to avoid the serial port route for now.. and I don't wanna chance losing the USB route (Even if I can bring it back via serial port).. so for now, I won't go past v55.499 (or if there's a different NA version that's next below 55.502, I can check).

I was really asking to find out incase I would have to have a different FW than mine, v55.. but I got AA to work this morning so I'm all set.

Now I'm going to see if I can figure out my video player situation (that's a tweak) and see if I can change it.. or figure out how to get it to start where I left off (if even possible)..
And then, or maybe even before.. but I'm gonna fix the touch screen..
Thank you guys again!!
 
@SergSlim
I'm hoping.. and kinda figuring it's just tge actual screen itself.. but I see what the prices are and if they're close enough then I'll just go ahead and get the whole 7 inch tablet part (...I guess thats the CMU)(The CMU, as in the whole screen part that sits on the dash, not the CMU for the actual car).
But this is an amazing community.. I ask just afew questions.. all on 1 forum.. and I'm all taken care of.. you guys have been extremely helpful!!
 
@SergSlim
Perfect.. thats what I kinda figured.. but you just confirmed it.. and plus I can see what to kinda expect.. so thats nice.

Do you happen to know what size speaker are in the front doors? .. my front passenger is blown.. and in having a hell of a time finding even the OEM speakers. My car does have the Bose system.. so I was trying to find out if I do get aftermarket, if they should be near a certain watt.
I believe it's 6.5 (just circled, so just 6.5).
And I came across 2 OEM numbers and I can't tell a difference between them.. they both come up as OEM. Both are:
BHN9-66-960
GKK866960
I dont necessary need to get the OEMs, but I would if they're cheap enough.. I was mainly looking into OEM to get the info for a replacement.
 
@SergSlim
Man your good lol
And quick... even with the CMU message..
Thank you again.. you've helped me out alot.
I'm about 99% sure it's 6.5.. especially now knowing the actual part number I'll be able to find it.
.. but wow, I was really impressed just now lol
 
Status
Not open for further replies.
You have insufficient privileges to reply here.