[Elmar]

Good day,

Since a few weeks im the proud owner of a Mazda 6 mt 2013. It has a lot op features but i always like the hidden stuff. I've already bought a ELM327 cable and activated the leaving home lights. Now im struggeling with the auto door lock mode. I used the spreadsheet and changed some figures but no result. Can anyone help?

Does anyone with a mazda 6 2013 tested the Bambi mode and Emergency stop signals as written in the sheet?

Many thanks,

Elmar
The Netherlands

 

[Elmar]

Auto Door Lock Mode: Have you considered 7B7-01-01 B1 b7 and 7B7-01-01 B4 b5 + b3 ? After changing the values, you might have to reset the according section in the MZD. Just open the MZD at the settings - car - lock page (i guess) and reset this menu, then the new menu should appear.

Thank you for your reply Tristan. I've tried the settings u said and several others and it finally works. The Auto door lock menu is now visible in the car and the doors lock when im driving. The strange thing is now that i receive an inspection message of the SCBS system. When i check the DTC i got 2 error codes: ICA U0415:68-28 and ABS C0023:62-08.
Below you see the bits that i changed.

When i change B1 b7 back from 1 to 0 the error codes are gone (so far, will check coming days) but the doors don't lock during driving even though the Auto door lock menu is visible on my car screen.

Anyone an idea why the errors are linked to that bit?

 

[Elmar]

This is the dead end if You like someone to solve your problems, cause You have indicated only the bits which You allegidly changed with "1" & some bits with "0". But nobody knows which values You really have in the bits marked with green.
If You really like someone to assist (especially to find the problems with SCBS after modifying) You have to publish exactly all the values of the both blocks 7B7-01-01 & 7B7-01-02 which in result were recorded into R-BCM

Your right, below i added 2 screen from forscan with and without the auto door lock setting.

Below: Normal condition no auto door lock.

Below: Auto door lock activated, visible on multi display and working without SCBS/ABS error. New problem, i can't open the trunk. Not with the remote or touch sensor in the trunk. Any suggestions or or setting tips?

Thnx! Elmar

 

[Elmar]

Did You ever try:
7B7-01-01 1DD2 0006 E79C
7B7-01-02 8709 1300 2084
???

Tried ur settings and it works! No problems anymore with the trunk lock Last question, do you know if its possible to unlock leaving home lights? I checked the RBCM and it showed not adopted, i do have a light sensor.

Thank you!

 

[Elmar]

7B7-01-03 0000 0210 D4

tried, doesn't work, to bad.

 

[Elmar]

Guys,

Is it possible to activated ESS on an mazda 6 2013? Im running code 726-01-01 F266 196A D8E2 currently, but no flashing when braking. Only bambi mode works with this setting. Wrong code or not possible on 2013 model?

Thnx

 

[Elmar]

Good day,

Does anyone know, or tried if its possible to activated DAA and SCBS-R on a mazda 6 2013? Car is equipped with FSC gen 1. Anyone tested this before??

Thanks