2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey,
So I recently installed AIO on my Mazda 3 2014 a few days ago on firmware 56.000 which worked perfectly.
This morning I tried to install Cast Screen and suddenly the screen got black, I restarted the car and the screen was stuck, I couldn't use the buttons either but only the mute/volume.
Now it doesn't work at all, no matter if I restart the car on put on switch mode. The screen doesn't respond.

Is there any solution ? As I know there is no warrenty anymore because of Android installed.
 
1 - 1 of 1 Posts
Top