2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
218 Posts
Discussion Starter · #1 ·
Hi all,

I need help! I'm installing a backup camera, but I'm testing it out first before I do the complete install and the screen is stuck (see picture).

I have the AVH-4200NEX and connecting to a 2013 Mazda3.

To test, I ran the video cable from front to rear and connected the power/ground into the backup light receptacle (I unplugged the connector and just stuck the power/ground into the two slots).

Everything was connected, I started up my car, put it in reverse and at first it didn't work, so I went into my settings to make changes and it worked.

So I turned the car off and on again just to make sure it would work before I put all the wiring where I wanted it and now I get the screen as seen in the picture.

I've unplugged the camera cable, reset the unit multiple times and it still shows this screen. At first I heard my music, but now I don't hear anything and none of the buttons work on the unit.

thanks,

jegonzo3
 

Attachments

·
Registered
Joined
·
218 Posts
Discussion Starter · #2 ·
I figured it out, hold down Mute.
 
1 - 2 of 2 Posts
Top