2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

Squeaking after camber arm install

1940 Views 8 Replies 4 Participants Last post by  Red_Hood
Wassup guys, so yesterday I installed some Megan Racing Camber arms on my 2007 mazda 3 sedan & the process was brutal (for the passenger rear at least lmao.) After I finished I took it for a spin and everything seemed good until later that night. Cruising speeds, the car sounds fine but when going slower on bumpy roads or up onto my driveway it sounds bad. Today I loosened the bolts and then retighten then completely by hand and it seems like it help a little bit but it still squeaks. Anyone have a similar issues or have any suggestions on what I can try? Thanks guys
1 - 2 of 9 Posts
Use the proper silicone grease. White lithium grease is not going to work very well.
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.