2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 1 of 1 Posts

· Registered
93 Posts
Discussion Starter · #1 ·
Looking at the other threads and some sites, it was described that the CPU board used for the CMU is ARM based. Has anyone tried porting the firmware image to popular ARM boards such as the Raspberry Pi or Odroid perhaps ? If someone wishes to experiment with the CMU such as the AIO tweaks, best to run it on a separate board instead of experimenting on the car.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.