2004 to 2016 Mazda 3 Forum and Mazdaspeed 3 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey all! Anyone have an efficient way to go about removing the rear Mazda logo on a 2018 Mazda 3 hatch? I have a feeling it has prongs, so would I have to entirely remove the trunk lining to get to it or is there a less pain in the ass way? Just trying to replace it with the evil m emblem. Thanks in advance!!!
 

·
Super Moderator
Joined
·
5,092 Posts
There are holes but you don't need to take anything apart. Its held on by 3M tape. Heat it a bit with a hair drier, then use some dental floss to get behind it and release the tape. A stiff credit card can help the process along too. Clean up any remaining adhesive with a soft cloth and some WD40 or a bit gasoline. Just make sure the area is clean and stick on the new badge.
 
1 - 3 of 3 Posts
Top