2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

REAR BUMPER DIFFUSER

25K views 28 replies 18 participants last post by  JoeMini 
#1 ·

Attachments

See less See more
1
#6 ·
I picked this up last week.



Got it yesterday. Fits good.
 
#13 ·
I was not able to mount it last night but I did snap a pic this morning. The lip does come shiny abs but I wanted to match the stock rear finish so I put two coats of plasti dip on it with no glossifier. Matches pretty close I think.

 
#16 ·
Installed this weekend. 4 screws and two stock bolts and some 3m hold it in place. I would recommend getting some thinner 3m so there is no gap.
 
#22 ·
Hear is the racing beat exhaust on it. I took the mud flaps off to see if I like it without them on. Still undecided.
 

Attachments

  • Like
Reactions: Nauticale
#24 ·
It has pre drilled holes. It is four holes that screw into the stock bumper, all of which are hidden if I decided to take it off. It has two end holes that connect to the existing screws under neath.
 
#29 ·
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top