Joined
·
236 Posts
First question - I'm hoping to install my amp under the passenger front seat. It is about 10"x8". For those who have removed the seat (I confess that I have not) is there room there? How would you (did you) secure the chassis down there?
Second question - power cable routing. Phase II will likely include a sub amp (so I can go active on the front components), but Phase I will power the sub cab from the main (6-ch) amp. So I was thinking I'd run 1/0 wire along the left edge and use a dist. block to send 4ga toward the passenger seat, and another 4ga back to the trunk for future use. Is this a good plan?
Thanks, friends! (and I apologize if these are very noob questions)
Second question - power cable routing. Phase II will likely include a sub amp (so I can go active on the front components), but Phase I will power the sub cab from the main (6-ch) amp. So I was thinking I'd run 1/0 wire along the left edge and use a dist. block to send 4ga toward the passenger seat, and another 4ga back to the trunk for future use. Is this a good plan?
Thanks, friends! (and I apologize if these are very noob questions)