2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 2 of 2 Posts

·
datsunnyit
Joined
·
133 Posts
Discussion Starter · #1 ·
Hi all
for install this 4 mud flap ( GENUINE MAZDA or aftermarket ) is necessary use the drill and create new holes , or the car have all holes ready to use ?

For fix this mud flap are necessary screws or only CLIPS - FASTENERS ?

2014 2015 Mazda 3 Front and Rear Splash Guards Mud Flaps 5 Door Hatchback | eBay

181226899545

Plastic Splash Guard Mud Flaps Car Mudguard for Mazda 3 M3 Axela 2014 | eBay

261654454770

Fit for 2014 Mazda 3 Axela 4 Door Sedan Mud Flap Flaps Splash Guards Mudguards | eBay

331267734063

or similar ?

Thanks
 

·
Registered
Joined
·
33 Posts
I purchased the genuine mazda mudflaps. On my '14 Mazda, the holes for the rear were not cut out. I used a pair of scissors to carefully cut out the slots for the fasteners.

If I remember correctly, you don't need to cut out anything for the front. That part was pretty easy.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top