The air flow from the vents seemed to have fixed itself, so that's good. Thursday morning I turned the heat dial to max and let it blow at max for about ten to twenty minutes and the heat finally kicked in. I tried replicating that this morning but the heat never did turn on after about ten to fifteen minutes of driving, maybe I needed to wait a bit longer, who knows. Not sure if this is common with SRIs or not but it seems to have effected my heating.
K&N SRI and Heater
I went and picked up my K&N SRI for my 2014 Mazda 3 and I installed it the same day. Tuesday morning I turned on the heat in my car to clear the windshield up from sitting all night and my car wouldn't blow hot air, it was blowing cool air. Something else that's strange is I'm also getting a lot more airflow from my left vent, next to my left hand, compared to the vents in the middle of the car; regardless of how high/low I have the fan blowing at.
I did the SRI installation myself and I didn't fiddle with anything aside from the crank hose and the air sensor, both of which I plugged back up. Anyone know the cause or what I could check?
I did the SRI installation myself and I didn't fiddle with anything aside from the crank hose and the air sensor, both of which I plugged back up. Anyone know the cause or what I could check?
1 - 2 of 5 Posts
1 - 2 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums
Come discuss all things Mazda 3 from the Mazda GT hatchback to Mazdaspeed, sedan and sport.
Full Forum Listing
Recommended Communities
