2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
I only recently noticed that the gap that the bottom of the truck/hatch makes the the bumper is not equal when closed. I can run my fingers under the left gap but not throughout the middle or the right side.

Never been in accident. Found it kind of odd. Any of you guys have this problem?
It doesn't affect anything but it's just odd.

See picture below


Sent from my LG-H812 using Tapatalk
 

·
Registered
Joined
·
198 Posts
Looks to me like the top of the bumper is bent down a bit on the left -- perhaps something very heavy was set there some time when loading or unloading.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top