2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Hi all, I just had a question on how to install the Front Air Dam that Mazda offers for the 2019+ 4th gen models shown in the image below:

Hood Grille Automotive tire Automotive lighting Automotive design


I have been looking everywhere on the internet to find any way on how to install this and how the part looks just on its own not on a car. Can anyone explain on how to install this thing or enlighten me on how it works? I'm not sure if you have to take off the front bumper or not.
 

· Registered
Joined
·
13 Posts
Discussion Starter · #9 ·
View attachment 289269 View attachment 289270
It slides over your existing "small lip" and is held in place by clips, adhesive tape and a few small brackets. Under my lip it is the same as yours, I have a Prem Plus turbo that comes with the air dam/lip. I had to replace mine due to road debris, aka a concrete patch that came out of the road. Its less than an hr. job if you're handy. Cheers.
Oh okay I gotcha. That makes so much morse sense. I will definitely be installing this on my Mazda 3 as well as the rear diffuser they offer. I think they just look so clean when they are on. Do you know when you purchase a front air dam from a Mazda dealer, does it come with all the hardware?
 
1 - 2 of 2 Posts
Top