2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
So I was going to install fog lights on my I grant touring. Got the kit and the switch. As I took off the driver side cover, the plug is missing. I looked all the way inside. Nothing. Weird. Previous owner ripped it off? Whatever. My question is, can I splice the passenger side and run the two wires to the driver side to connect that bulb?? Of course I would buy the h8 plug. Any drawbacks by doing this?
 

·
Registered
Joined
·
165 Posts
According to the wiring diagram, there shouldn't be a problem. Just make sure you wire positive to positive and negative to negative. Also, if you can find where it was cut off, tape so there isn't a chance of shorting out.
 

·
Registered
Joined
·
43 Posts
Discussion Starter #3
Yea. I didn't think there would be a problem. And didn't realize the fog light kit I got has h8 plugs. Lol. I couldn't find where the driver side harness broke thou. Hmm I'll check again.
 
1 - 3 of 3 Posts
Top