2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
So I recently installed an Ultimate Racing exhaust on my 2016 Mazda 3 Hatch. It only has 2 of the pinhooks to secure it as opposed to the 4 that was on the original muffler. I was wondering if anyone knew of a good way to pull the exhaust up so that it sits more flush with the bumper. I won't be doing it until after the rolled angle cut tips come in but all suggestions are welcome.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top