2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

Creaking noise - front end

2286 Views 5 Replies 2 Participants Last post by  arathol
when I had my clutch replaced, I noticed a creaking noise after the work was performed. Clutch seems to be fine. My shocks and struts were way overdue to be changed out so my son-in-law swapped them out. That improved things but I still hear the creaks when I accelerate or make sweeping turns. My son-in-law mentioned it may be my sway bars.

thoughts?

Any way to determine what this might be before I bring it in to have Mazda take a look at it?

Thanks!

Bill
1 - 2 of 6 Posts
Sway bar bushings probably. Get some spray lube - not WD-40 :surprise:- and give them a shot.
White lithium grease tends to hold dust and grime when exposed to most driving conditions. In a fairly short time it turns almost to a glue and no longer has any lubrication properties. Use a good spray oil. Anything that does not evaporate quickly or gum up with dust should be ok. Chain and cable lube products seem to work just fine. I have a can of Lubriplate I use on mine occasionally.

https://www.lubriplate.com/Products/Specialty-Lubricants/Chain-Cable-Fluid-Chain-Cable-Heavy.html

[ame]https://www.amazon.com/Johnsens-4723-12PK-Chain-Cable-Lube/dp/B00C872W4K[/ame]

$300 is very high, but thats probably mostly labor. The parts are cheap and not really difficult to replace. If you have a jack, some jack stands, some tools and a bit of mechanical aptitude, it should not take too long to replace them.
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top