[Theonlyforte]

So I was driving home the other night and drove through a deep puddle and it completely shredded my engine splash shield, half of my clips on my bumper ripped (as seen in picture) and the splash guard is dragging. Most of it is being held by zip ties at the moment but is there another solution to this problem? I think if I get new guards they wont stay on because the clip holes are ripped on the bumper.

 

[Hi Im Mike]

Same thing happened to me when I got stuck in the snow and had to back up and go forward over and over. Still being held by zap straps too :/

 

[kms1990]

new guard and use small self tapping screws and go beside the old holes where plastic bumper is and it will create new holes and hold it just fine

 

[Theonlyforte]

I'll try that out thanks!!