2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
267 Posts
Discussion Starter · #1 ·
Cant find these anywhere but wiring through the molex isn't that bad. Just push the wire through the existing hole. Used the existing tweeter wiring as the input for the crossover and ran new wiring to the door speaker and new tweeter.

2016 mazda 3 front speakers. https://imgur.com/a/YNYut
 

·
Registered
Joined
·
267 Posts
Discussion Starter · #3 ·
Where did you place the crossover? Underneath the tweeter in the dash?

Did you have to remove the dash to run the wires?
Both sides drop straight down and easily accessible from below. Just remove glove box (tool less) and you will find plenty of room. Youll have to get on your back on the driver side but there is plenty of room there as well.
 

·
Registered
Joined
·
163 Posts
Hi, I'm about to put component systems on my Mazda 3 as well. I am guessing you reused stock tweeter wires? How do those connect to the crossover?
 
1 - 4 of 4 Posts
Top