2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

2.5 exhaust direct bolt on to sky?

4K views 23 replies 13 participants last post by  lawwl 
#1 ·
Anyone cut Skyactiv bumper for dual exhaust?

Hi
I want dual exhaust but not going to buy a 2.5bumper.
Anyone successfully cut it?
Pics? Instructions?

Thanks


Sent from AutoGuide.com Free App
 
#2 ·
I did it to my old sedan not skyactiv though. Ill look for pics it was hard to tell it was cut from far but when close you could tell.
 
#5 ·
Here I found these pics

 
  • Like
Reactions: lilweezly
#12 ·
Better flow due to less bends and piping length. It may be a butt dyno, but I feel like there is more power up top without much if any power or torque loss down low. I did bump up my piping by 0.25" to 2.5" piping.
@lilweezly
 
#14 ·
Hi
I want to get dual exhaust onto my 2013 skyactiv
Is the 2.5 exhaust a direct bolt on and off?

The only hack job modification Im willing to do is cut a hole in my bumper.

I'm not looking for performance, just aesthetics.

If it is a direct bolt on and off. Up to which parts of the exhaust do I need?

Thanks


Sent from AutoGuide.com Free App
 
#17 ·
I put a Racing Beat 2.5L on mine. Direct bolt on, hangers and all. The bumpers are a direct swap too.
 
#23 ·
Any recommendations?




Sent from AutoGuide.com Free App
Bro keep all your exhaust questions for the Skyactiv on this thread. You created at least 5 in a few days and its going to clutter up the forum. So just ask away here! Now big exhaust what do you mean?

Phil
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top