shocks

This suspension setup is from a 2015 Mazda 3 Sport 4 door with +92k miles on it. I have the original manufacture shocks, struts, and springs. There was nothing wrong with them, no leaks, and they performed well. The reason I am selling these is because I just installed a new setup to lower my...

I installed new Monroe (just oem) rear shocks on my 2010 Mazda 3 GT 5 door and the rear end is squeaky... sort of a rubber sound. It happens often and did not occur prior to installing the shocks. I did not replace anything except the shocks. My mechanic replaced the shock mounts about 4 to 6...

This is also an introduction first post message. :) I realize that some may just want to point me towards the search button - but I wanted to say hi and this is more fun. 0:) I bought a dark red 2008 GT notchback with a manual a year ago, has 128,000 km on it - and is mint. It's going into...

This is also an introduction first post message. :) I realize that some may just want to point me towards the search button - but I wanted to say hi and this is more fun. 0:) I bought a dark red 2008 GT notchback with a manual a year ago, has 128,000 km on it - and is mint. It's going into...

Hey guys I've been sitting on corksport springs on stock struts since I think 30k. I'm now at 72k and one of the struts have a small leak. The ride quality has degraded a little over time but nothing too bad. I can't tell half the times if it's the shocks or the horrible roads in Hawaii. I...

2010 Mazda 3 Sedan. Id like to stick to OEM specs; no lowering. Bilstein? KYB? I'm not a Monroe fan. Any recommendations?

Hi everyone, I was searching online for rear shocks (prefably monroe) but it says that the ones for 2011 model needs a longer mounting bolt? I found one on amazon, It says that these work for the 1st gen mazda 3, but for 2nd gen, u need to make adjustments, could someone point me in the...

I just bought Koni FSD's, and I started to try and install the rears. OI removed the 2 top nuts and the nut and the washer that was on the bottom. Problem is our models have the bottom mounted on a stud and I tried for hours and could not get the old shock off the shaft. Has anyone actually...

So my 16 sport had a Knoi FSD / H&R setup and I loved it, I very recently moved to a 2018 GT Premium (all the spaceship stuff + Manual!) and was able to salvage my CS exhaust, intake and wheels. Suspension is a bit more complicated so I had to give up somewhere. So in starting part-way over and...

Hello all If my BM Mazda3 is lowered by about 35mm and I wanted to get new shocks/struts, what would be the best to get? Springs are King Springs (Australian brand, I think?)

anyone else have problems with there rear axle make a very freaky thunk like it is running the enter length the suspension. I also have a problem with my sway bar any recommendations The car is 2006 Mazda 3 s 2.5L base so not like it is the expensive modal but it is my car so i would like to...

Looking for OEM front shocks for sGT 5dr, preferably low mileage. Local pick-up would be nice.

-hey guys, i want to lower my car but still dont have the money to buy new shocks as they are quite expensive, the question is, how long will the stock shocks last with the eibach lowering springs? thanks

Fellas, I had my Mazda up on jackstands to remove the front rotors and have them resurfaced. With the car up in the air, front suspension fully extended I noticed the dust caps on the struts were un attached from the top or the bottom of the strut. I tried to push the lower portion of the dust...

My 2014 3i 50k miles has a leaky left rear shock and worn rear brake pads per the dealership. I wiped my finger on the shock and a small amount of dirt/grease came off, but did not feel wet. The car is not bouncing like crazy over bumps, and I do not know how else to test this shock. I want to...

Hi all, Was wondering if anyone or knows someone who has used the CS adjustable shocks and struts? Looking into these as an alternative to the usual Koni, Bilstien, ect. They also happen to be 10% off the original price. Could be a steal at $450 for the set. Any thoughts? Thanks.

Hello there! Recently browsing online for aftermarket shocks/struts and saw the Corksport adjustable struts and shocks. Anyone already has it? Or anyone getting these? Feedbacks please. ??

So i am newer to this, but i just redid my braking, and i want to lower my car without spending a fortune. can i lower it by using just springs, or do i need to get new shocks/struts. i dont want to lower it a lot, 1-1.5 inches is plenty. i drive a 2012 sky-active sedan

Okay....well, its been a while since I've posted something on the forum. But, as the title suggests, I have been having an issue with a knocking/ popping noise coming from the back of my 2011 mazda 3. I've looked around the different forums and threads regarding this noise and a majority of...

Hey, I have a mazda 3i touring that I want to lower with tein s-techs. Now i'm wondering if I should get the springs first and ride on the stock shocks until they need replacement (instant gratification, more money on alignments). or wait and upgrade both shocks and springs at the same time to...