2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

screws

  1. 2014-2018 Mazda 3 Skyactiv Discussion
    I would like to replace the plain steel screws that hold the rear license plate to the car with black screws to match new black frames. Unfortunately all the black fasteners I can find have threads for domestic cars. That works on the front license plate that fastens to the plastic grill but...
  2. 2014-2018 Mazda 3 Skyactiv Appearance & Interior
    I bought some alloy pedals a few months ago but never got around to installing them, now i can't find any of the screws or washers etc it came with, it's a set that requires drilling for all 4 pedals and i can't figure out what size screw I need to buy to install them properly, any help would be...
  3. 2010-2013 Mazda 3 & Skyactiv How-To Guides
    So if you're here you've probably encountered this: Literally the most annoying thing ever, so we're going to convert those stripped problems to these: So here's what you need in a picture: And also in a list: Wheel Removing Tools: (For easy access) Jack (Not in picture, should be obvious)...
  4. 2014-2018 Mazda 3 Skyactiv Appearance & Interior
    I was kinda annoyed when I found out there are only two screws at the top... I've been considering adding the bottom screws but I don't really want to add holes to my car... I have a plate frame right now, with fake screw tops so it looks even and covers the bottom holes of my plate.... But...
  5. 2010-2013 Mazda 3 & Skyactiv Discussion
    I'm hoping this is an easy question. I just bought a Mazda3 at a Hertz Car Sales that came with out the front license plate bracket.(Mazda dealership wanted $80 for bracket and install) No problem, I bought and installed the OEM bracket, however what type of screw or bolt attaches the license...
  6. 2010-2013 Mazda 3 & Skyactiv Discussion
    Sorry I tried searching for this but I want to confirm that the number of screws on the 2012 models are still the same. Can someone please tell me how many screws will I need to remove from each side (top, left, right and bottom) in order to remove my bumper? As well are the screws metal or...
  7. 2010-2013 Mazda 3 Engine and Performance
    One of my stock mass air flow sensor screws has bonded so tightly to the standoff that corksport gave that i cannot get it out. The standoff came out of the intake. I want to go back stock, but i cannot get this standoff off of my maf. Another Corksport geinus engineering. The standoffs should...
Top