im sorry for double posting this, i accidentley posted to the wrong forum. so here goes... hello, im not sure if this is the right place to post this but here goes. i have a 2004 mazda3 and when i turn the wheels theres a clicking or rubbing noise and the faster i go the louder the tire noise...

hello, im not sure if this is the right place to post this but here goes. i have a 2004 mazda3 and when i turn the wheels theres a clicking or rubbing noise and the faster i go the louder the tire noise is. i too it to the shop and they told me that i need new driver side wheel bearings. i...

I am on the Eibach ProKit. My wheel specs are 19x8.5 ET45 with 245/35 tires. I tried measuring by putting a bunch of weight in the back to simulate full compression of the suspension but I am not sure if I achieved that as it didn't go down very far. Has anyone tried this? I supposed it would...

I had a question for people that have lowered their car on springs, have more aggressive fitting wheels, and how they account for rubbing... both when they're solo driving, then when they have a full car or a heavy item in the trunk? I want to either get a 18x8 +35 in the future, or short term I...

I recently bought some BBS Rs' for my car, and when I had them mounted on this weekend my rear tires started to rub against my fenders. I mounted the rims on my stock tires, but I'm on H&R lowering springs so I think that's part of the problem. I rolled my fenders in the hope that this would...

recently after we lowered my car it rubs. Everytime I go over a bump (even if it's little) the front right of car makes a loud apart scrapping noise. It's not my front bumper hitting the ground. It's coming from in the wheel well. Can't figure out what it's hitting. My fender liners are cut so...

Hey all, I recently installed the Corksport Coilovers and am currently adjusting my height and all of that. Right now, the fronts sit a little lower than the backs just because I haven't been able to adjust that just yet. Up front there's only about a fingers worth of gap and on the back it's...

When I installed my new HPFP I discovered my CorkSport TIP has been rubbing up against my ECU plastic casing. Its taken a lil notch out of the plastic and left a flat spot on the TIP. I plan to call CorkSport on Tuesday but I doubt they will do much since I bought the part around 2 years ago. I...

Hey my buddy and i just installed lowering springs on my car and for what ever reason the front left spring is rubbing on the wall. We tried re-setting the spring and no matter what we do it still rubs. The right side is close but does not rub. Anyone know what this could be?

got my 2010 sitting on a set of bc coils and xxr 530 18x8.75 +35.wondering if anyone else has achieved a nice fitment on there 2nd gen aswell and if you had any problems with rubbing in the front.and if so how did you correct it.im trying to go as low as possible without rubbing. and if anyones...

I've had the SRI and CS airbox on my 2.5L engine for a few months no issues yet, but I am concerned about the rubber arm of the SRI rubbing on the air box. When I installed it I tried to center the SRI tube in the hole for the airbox but no dice. I didn't want to make a cutout in the airbox to...

im running coilovers with a custom 135mm spring, i am rubbing on the inside with the tire does this mean I have need to alignment asap because it is so messed up whats the deal? *im running stockers

So recently I have noticed a humming or rubbing noise when pulling into parking spots my suspension has never been touched anyone else encounter something like this?

Right now I am rocking the stock 17" wheels with 205 tires... I have a NON mazdaspeed3 hatchback, I know the wheelbase is different, hence why I am asking for advice here. Does anyone know how big I can go WITHOUT adding spacers or messing with my suspension/fenders?? I was planning on...

If any of you have ever wondered what a Mazda 3 would look like if it rubbed wheels with a 18-wheeler at 70mph, here you go. Surprisingly, the tire appears to be undamaged and I was able to drive the car the rest of the way home (another 150 miles). Yes, I need to redo my calipers. The...