Search Results for ‘resistor’

Hello all, I am new to Mazdas, picking up a 2016 3 i Touring Hatch last friday. So far I have really enjoyed it. I am having an issue with the the heater fan always blowing at a constant speed no matter the setting and if I turn it off it still blows constant and shows the setting its blowing...

Folks, Where did you mount your load resistors? (front and rear) Did you bolt them down? Is a resistor mounting plate worth it? Thanks, Michael

Hi everyone, I have been looking around to see if there is a "step-by-step" on how to remove and replace the blower motor resistor on a Mazda 3 2010... The fan only turns on when I am on "4". Nothing works on 1-2-3 levels... From what I gathered, it seems that the issue would be the resistor...

My girlfriend drives a 2010 Mazda 3 (2.5/manual) and has been having issues with the passenger side lower console heating up extremely hot to the touch while the A/C is on. I attached a picture of exactly where the heat is sourced. It doesn't do it when the A/C is off or if just the blower is...

Hey everyone, is a resistor necessary to use led drl's? Just checking before I order. Thanks.

is it safe to use one resistor in two smd bulb?

I see most people installing their resistors in the front, which seems really difficult to reach... and to isolate the resistor from other wires (resistors get very hot). I tried looking up if I could install the resistors in the rear, and have them work for the front signal bulbs, but I...

is this avail???? to prevent hyperflash with out having to mount a seperate resistor:sad 1: