2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

radiator

  1. Full Aluminum Race Radiators

    2014-2018 Mazda 3 Skyactiv Engine and Performance
    Hello All, Nobody makes a full aluminum race radiator for the gen 3, so I am sizing up off the shelf options for an adapt-to-fit setup. So far I have narrowed it down to either a 2002+ Acura RSX (Mishimoto 2 row) or a 96-ish Civic half size (Mishimoto 3 row). CAD images below to compare to the...
  2. Condensor / Radiator fan not running

    2010-13 Mazdaspeed 3 Engine and Performance
    2010 3 hatch 2.5 I noticed the fan not running when the a.c. was on, so I eventually figured out that the ground cable assembly was bad. I also put a ScanGague2 in so I had a temperature gauge. Again the fan wasn't working, so I ordered a Four Seasons brand from Rock, and installed it last...
  3. How to remove the radiator grille

    2014-2018 Mazda 3 Skyactiv How-To Guides
    Hello, i would like to change the radiator grille lower molding(shown as the picture below), but i don't know how to do it. Please tell me, thank you.
  4. r&r radiator on a mazda

    2010-2013 Mazda 3 & Skyactiv Discussion
    I have a 2010 mazda 3 hatchback 2.5 I think I might need to replace the radiator due to it leak leaking at to drain valve I tried to tighten the drain plug no luck Tom
  5. Radiator fan not spinning

    2010-2013 Mazda 3 Engine and Performance
    Hey everyone, so I'm pretty new to this scene and I'm loving my '13 3 hatchback but it started to overheat on me on my way back from work the other day in some stop and go traffic. Luckily I was able to pull over before it actually overheated and let it cool off. Here are some of the problems...
  6. Radiator reservoir coolant

    2014-2018 Mazda 3 Skyactiv Engine and Performance
    Just checked my coolant reservoir and its almost in the low level. Can i just top it off with any brand of coolant?
  7. How do I fix this?

    2010-2013 Mazda 3 Engine and Performance
    Okay so yesterday after driving around I come back and I hear this hissing noise after turning the engine off. The noise was coming from the lower front of the radiator although I couldn't see what was wrong. Since this was bothering me I opened up the front bumper to get a better look at the...
  8. Radiator hose diameter

    2010-2013 Mazda 3 Engine and Performance
    Gauge install woes continue... After the heater hose adapter didn't work out, I purchased the sender adapter from Prosport, 32mm diameter. I did some research before and found that the radiator inlets were 33mm, so no problem right? Well I've been doing more research, and have been finding...
  9. WTB: Speed3 Front Clip, Bumper, Radiator, HID Headlamps, etc...

    Mazda 3 Parts - Buy / Sell
    Need front-end parts for 2007 Speed3 - hood, fenders, grill, bumper, lights, etc... Prefer complete front clip
Top