Hi, Can anyone tell me the name of the panel that is above the grille and below the hood on the 2016 Mazda 3? If you know the part number, even better. Thanks!

I've been searching for a replacement driver's side door for my vehicle and want to clarify a compatibility question. Do the sedan and hatchback use the same doors for both front and rear? I thought I saw something at one time which stated they do, but I want to clarify. I do know the front...

I am working on adding a front and rear dashcam to my car, a 2018 Mazda 3 hatchback For the rear camera, I've found enough information that I have been able to route my cabling to the rubber tubing that goes to the rear door, but not much after threading the cable through the rubber housing...

My new-to me 2004 Mazda 3 came with a shift boot that has seen better days. There seems to be a lot of generic ones made online, but not very application specific ones. I found a used MazdaSpeed3 shifter panel with an OEM shift boot installed from an 07. The tabs and size look almost identical...

Hi people, I'm acquiring parts for my Mazda 3, but when looking at the diagrams the shift panel doesn't match the photo. Can you help me? It's a Mazda 3 HB 2017, touring PART: BBNL-64-340C

I've been noticing a very hot spot in my passenger side lower panel as circled in the attached diagram. This only happens when I've enabled the fan (with and without a/c). If I remove the panel cover (the same one you would otherwise remove to access your cabin filter/bm resistor) and poke my...

Hi. I am new to Mazdas and I need some advice on a problem. In between the speedo and rev counter there is a small LED(I think) panel that used to tell me what gear I was in, how I was driving etc. The panel has stopped working now. It flickers on very briefly when I start the car,but then...

Dears I have a problem with the lights in front and light of my M3 turn On when going driving this the stop light, stability light, ABS light and other for 3 seconds and then by discontrol turn on and turn off very much the frontal focus, please help me I don’t how fixes this problem. 3 days ago...

Anyone know what this is (photos attached)?

Does anybody have instructions or knows how to remove the Driver Side Lower Panel? I need to fix a rattle coming from that area and I'm not able to find proper information, or videos. Waiting for your advise or any suggestions. Thanks.

Anyone have any success fitting component tweeters in the stock location without cutting up the sail panel? Mazda 3 2007 hatch 6 speaker non-bose.

Greetings! I have a question that hope to be answered by the Mazda 3 fans out there. I just did my first oil change on 2017 3hatchback at a local dealer. I noticed the plastic access panel to get to the oil filter looked bended after the oil change, not completely even. It does have all the...

I am trying to find the part number for this moulding that cover the pinch weld along the rocker panel. Can anyone help?

Hello, I have a 2014 MAZDA3 GS MODEL Sedan (Non-Bose). I've searched and I can't find any information (even in the 10,000+ page service manual) on how to remove the small plastic panel which contains the TSC, TPS, etc sensor switches below and to the left of the steering wheel. I have a...

Rudimentary guide to removing front door panel on Mazda 3 w/ Premium Package. This is just a guide and I am not responsible for any damage or injury that may occur from using this guide. Start Here (Driver's side is similar): Take a right angle pick or flat head screw driver and remove the...

Driver's side interior door panel loose on my newly purchased 2008 Mazda 3 i -- is this an easy DIY fix or do I need to go to dealer. Panel is still attached but obviously loose and pulls away from door. Thanks.

I'm comparing specs on the different reusable panel filters that we have as options. I can not seem to find the dimensions of the JBR or AFE (Pro Dry S) filters. Length and width of course are not as important, it is the height that I'd really like to know. If anyone has one of these, any...

Been researching the different drop in panel filters. Think I have it boiled down to the JBR but had a couple questions.. 1) unlike a cone filter where you can clean it without contaminating the inside with the dirty water, panel filter seems like it would be hard to clean.... so I guess...

I was looking on how to remove the driver side lower panel from the service manual, and it says that I have to remove a lot of other stuff before I attempt to remove the panel itself. Do I really have to remove all of the items listed or they just list them as optional? I can't really see the...