2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

jacking

  1. Jacking points/locations

    2014-2018 Mazda 3 Skyactiv How-To Guides
    I'm looking for a way to do my own tire rotations easier and quicker. In the past I would jack up one wheel at a time by removing the first wheel and putting the spare temporarily in it's place, then jack up the second wheel, remove the wheel and replace it with the first wheel I took off.. and...
  2. Jacking spot for the rear of the car?

    2010-2013 Mazda 3 & Skyactiv Discussion
    Does anyone know where a good place is to jack up the rear of the car? Thanks in advance! :)
  3. Already messed it up. Bad jacking point

    New Member Introduction & Forum News/Guide
    Well Hi. I picked up a 2011 3s with the 6-speed manual about a week ago. My past cars have been a 91 N/A RX-7 and a 02 Corolla, both with a manual transmission. This post is also my TIFU post. http://mazda3revolution.com/forums/2010-2013-mazda-3-skyactiv-discussion/13799-jack-points.html See...
  4. Jacking Points

    2014-2018 Mazda 3 Skyactiv Discussion
    Where are the front and rear jacking point for our cars? Looked all through the owner's manual and could not find anything. I'm not talking about the pinch weld spots for the emergency jack but for the area in the center of the car where you can use a floor jack.
  5. Skyactiv front jack up point for floor jacks

    2010-2013 Mazda 3 & Skyactiv How-To Guides
    Update: July 28, 2013 - Confirmed by looking at Mazda website that for 2013 Mazda 3 Skyactiv, the jack up point is exactly the same as described below. If the Skyactiv has the same rigid jack up points as the Mazdaspeed 3, then I think I've found the point on the Skyactiv. This is the workshop...
  6. Jacking in

    New Member Introduction & Forum News/Guide
    Whats up guy jacking in to the forum. I spend alot of time on the Mazda3 forums looking to see whats happening here.
  7. Jacking

    2010-2013 Mazda 3 & Skyactiv Discussion
    Where are you guys placing your floor jacks when jacking up your car? When I changed my oil 2 or 3 weeks ago, I used the bolt for the rear engine mount (shown below). It did not work out too well since the mount is not in the center of the car...
Top