Search Results for ‘hub’

I can't seem to find a thread that discusses how to change the front wheel bearing hub assembly for the '14. Am I just overlooking it or has this never been thoroughly discussed? I've looked at the service manual and it looks fairly straightforward and not to unlike previous models. Can...

Hi all, Any ideas would be appreciated. Just finished installing the new hub and cables but now the top usb port (the CarPlay one) does not recognise the phone at all. The bottom one works as expected -> phone charges, says USB 2 connected, can select in entertainment sources to play music...

Do everybody try to using external usb hub on Mazda Connect to add more usb port? I try to use one but the CMU did not detect it at all, i think may be CMU don't have driver for it..... May be some one know how to install driver on CMU for external usb hub. Thank and Best regards!

when i type my question into google it gives me bolt pattern which is not what im asking... I want to know if the wheel hubs from a 2014 sky would work on a 2013 sky. mine are not bad yet, but rockauto doesn't have a listing for many skyactiv parts for 2012-13, and i would much rather buy the 14...

I just replaced the rear wheel hub yesterday because the bearing is broken. This wheel hub (bearing + housing + bolts) is quiet expensive here. Is it possible to replaced only the bearing by pressing?

Hi. 2013 Skyactiv, and putting on '06 RX-8 wheels with 235/40/18. Front is spaced well, but was thinking of bumping out back with a 5 mm spacer. However, I am concerned that there will not be enough of the centre hub protruding beyond the spacer to go into the wheel bore to keep it centred...

$80.00 shipped

$80.00 shipped

Hello, just approached 5000 miles on my 2016 Mazda 3 and am doing a tire rotation. I noticed a lot of rust when doing so, is this normal or should I take in for warranty? Please help :( Thanks

Considering picking up some gen2 speed3 rims. Since they are oem, is it necessary to get hub centric rings for a good fit, or should it be fine? Thanks! [emoji41] Sent from my SGH-T399 using Tapatalk

Anyone happen to know the width of the lip at the hub where the wheel rests? I want to try 8mm spacers for the rear and am wondering if doing so will render the hub non centric. Thanks

Hi i own a 2008 mazda 3 4 door sedan and i recently ordered a mazda 3 Nrg short hub off of ProImportTuners.com and they sent me a part that doesnt fit. i was just wondering where i can order a short hub for my car that i know will forsure fit.

Hi All, What do you suggest for steel wheels on my 2014 Mazda 3 GT? I'm going with 205/60r/16 basic steel but what about this Hub centric vs Lug centric thing? (these are for my winter tires) Should I just go with the cheaper Lug type or pay more for Hub centric? What do most people go...

Hi all, Although I've experienced a few system crashes before, this one was the worst one yet. I was playing music through the USB port and had home as my destination on the navigation system. Suddenly, both stopped working and froze the display. The USB ports were no longer providing power...

I purchased a set of 17x7 Sparco Tarmacs from Tirerack. The order included centering rings and tuner lugnuts. The centering rings that they included are plastic, Gorilla brand. The rings show 73.0mm OD and 67.06 ID markings. They fit quite snug when installed in the wheel. I've heard that...

A