2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner
fenders
1-9 of 10 Results
  1. 2014-2018 Mazda 3 Skyactiv Wheels and Tires
    Hello, I recently got a 2018 mazda 3 5 door GT. I do not like how far wheels are sunk in compared to fenders. I am thinking of putting 20 mm spacers in rear and 15 mm in front. Ideally it would have been 15 and 10 rear and front respectively, but I do not want to go through the hassle of...
  2. Wheels / Tires
    Hello, I recently got a 2018 mazda 3 5 door GT. I do not like how far wheels are sunk in compared to fenders. I am thinking of putting 20 mm spacers in rear and 15 mm in front. Ideally it would have been 15 and 10 rear and front respectively, but I do not want to go through the hassle of...
  3. 2014-2018 Mazda 3 Skyactiv Appearance & Interior
    I have noticed (as I am sure many of you have as well) that we are getting the shaft in the US when it comes to aftermarket support for our BM chassis. I am scouring the interwebs looking for this to no avail. Does anybody have any information on this kit or is it a custom fab?
  4. 2010-13 Mazdaspeed 3 Wheels and Tires
    Putting a set of 18x8.5 et35 wheels on a 2010 Speed 3. They`ll fit well and give me a meatier look. Not going for anything radical. I **HATE** the stretched tire look. Hate it. Tires I`m going to run are 245/35/18, and if my math (and hours of reading) is correct, it *should* fit up just about...
  5. Mazdaspeed 3 Parts - Buy / Sell
    My car was hit from the front but caused some damage to the fenders. If you think you can fix these and want to use them then hit me up. located in Moreno valley Ca 92553
  6. Buy / Sell / Trade
    Looking for a set of OEM, front fenders from a Gen2 MS3. color doesn't matter, paint chips are fine. no bends or dents. bonus points if you have the bumper too. PM or post what you have. (for wider front fenders in case your wondering)
  7. Middle Atlantic Region
    Need my fenders rolled and pulled NJ Alright I live in north jersey and just installed rims today that require a little bit of fender love. Anyone know where I can get them rolled and pulled? I can do it but don't have the tools and I don't have the patience. If you know somewhere or someone...
  8. 2010-2013 Mazda 3 & Skyactiv Wheels and Tires
    Hey everyone, I need to get my fenders rolled and the guy that i'm looking into charges 80 dollars to roll all four fenders. But i was curious as to if i even need to get my front fenders rolled because they do not have a lip on the inside of the fender like the rears do. If i can save 40 bucks...
  9. 2004-2009 Mazda3Appearance & Interior
    looking to go lower on my mazda 3 without rubbing?
1-9 of 10 Results
Top