Parked my 2010 Mazda 3 for a couple of months, now the engine give one or two weak cranks and then nothing.
Here's what I've checked so far:
replaced battery with a confirmed good one
checked battery terminals and cables for continuity
cleaned battery posts and terminals
I hope everyone is doing well. My little sister has been having issues with her 2011 Mazda 3 Hatchback. Where her car would have trouble starting; no crank. This is an intermittent issue where if she waited several hours it would start up again. However, this intermittent issue became...
So I just got my crank pulley from corksport not sure if there will be benefits but with aftermarket parts so scarce for 3rd gen I guess every part COUNTS LOL if it doesn't atleast it looks cool.
Question to people who has it installed already how is it holding?for you guys?
I have Mazda3 2014, 2.0L.
This is happen quite often, When I hit the button start, my car start immediately without engine crank.
I think this is not good for the engine cause of noticeable engine shake and sometime a knocking noise :frown2:.
Does your car crank too short sometime...
ive tried searching online and havent been able to find anything. is there any way to get more of the horsepower from the crank "transferred" to the wheels. a way to prevent a loss of power when getting the power to the wheels
Looking up on the advanced timing mod some ppl have done.
Spark timing makes sense but there's a wide notch on the teeth, is that the start of the cycle?
4000rpm = 66.6666~rps
judging by the picture from the other forum, there's 36 teeth in total. If every 4 teeth is one ignition...
Here's my problem. I left my hose today, car started fine, dash and trip computer looked normal. About 2 minute later I looked at my dash and it was black (not lit) and my trip computer had "---" on it for the outside temp, mpg, and everything else (while I was moving). The car was...
Since there doesn't seem to be a light weight crank pulley coming out for the 2.5L engine any time soon I went ahead contacted Unorthodox racing to see if I could put something together for us. This is the email I got back from them:
The Mazda 3/6 crank pulley requires an intricate installation...
omfg it's jeremy just pm'd me asking about whether we were going to do underdrive pulleys.
Right now, we offer a lightweight crank pulley for the early BP powered Protege's, etc. Here's a link to one for an example: CORKSPORT Lightweight Pulley For Mazda 1.6/1.8 DOHC
The 2010 is a little...