Search Results for ‘blower’

After about a year of the blower slow to kick in and randomly kicking out in my wifes 2005 I decided to do something about it. I suspected the blower motor relay bit did some online searches, including here, and found that it was NOT the blower resistor but could be just increased resistance in...

Battery died for some reason (maybe me leaving something on overnight) Called CAA and dude battery jumped it. After he left I notice both left & right signals, emerg. flasher and the Heater fan not longer worked. I looked under the hood today (Superbowl Sunday) every fuse was good. If anyone...

Hi all, I have a 2006 Mazda 3, the blower fan for the heater doesn't come on until the engine hits top operating temperature, (right in the middle if the dash temp gauge). Has anyone seen this before or knows what the issue might be? Thanks in advance, Walker

Hello, I think there is something wrong with my 2016 Mazda3. I was wondering if anyone else has experienced the same issue. If I have the blower on high and heat you can hear the blower temporarily slow down if I flip on the bright head lights. Is the alternator not providing enough power...

My daughters 2006 Mazda 3 fan blower is intermittent and getting worse. Any ideas? It's cold in Minnesota! Thanks!

Hi everyone, I have been looking around to see if there is a "step-by-step" on how to remove and replace the blower motor resistor on a Mazda 3 2010... The fan only turns on when I am on "4". Nothing works on 1-2-3 levels... From what I gathered, it seems that the issue would be the resistor...

The blower motor on my 2013 GT has been acting up lately. It first started making a subtle clicking noise when the fan was on which led me to think it was on its way out. Recently, the fan won't come on until about 10 mins of driving, and while on it makes some pretty bad noises (like the...

HOW TO: Clean inside the blower fan wheel/fix ticking from vents First write-up, bear with me if formatting is wrong. I recently had a mouse destroy my engine cover and take a lot of the padding into the "mouse cage" heat/AC blower fan wheel, causing poor performance and ticking from the...

The relay output is 14V, all fuses are fine. the blower motor resistor has 14V (car running), with the fan switch in the off position and when I turn the car on and go through the switch settings, I only get about .3 v present on all 4 settings. Is my resistor bad? What should the output...

I am trying to remove the blower case that houses the air intake actuator (for fresh/recycle air) in my 2010 Mazda3. Does anyone know how to remove the top screw from the blower case shown in either of these pictures...