Hi. I've searched high and low and cannot find any instructions for the PAC AOEM-MAZ2, or for an amp for the door speakers.
Where do I find the plug for the OEM head unit that I attached the PAC unit to?
For those of you who've done your own amp install, how easy/difficult was it? I've done a...
I have hooked this unit up to my 2015 Mazda 3. I am a little confused as to how this works.
I already modified they speakers in my car to fit my new speakers and they work just fine. I want to install the AMP in my car and I already ran the wiring in the car.
My question is since the speakers...
I was wondering if the display functions when using the PAC AOEM-MAZ2. I've tried the Metra 70-7903 and 71-7903 harnesses but the display does not show any info, it just lights up and shows "welcome"(looks like data cables are not included in the harneses) and you need to cut/splice the harness...
I am selling a slightly used PAC AOEM-MAZ2. It is a line output converter to allow you to add 1 or 2 amplifiers to a stock Mazda stereo. Please be aware that this LOC will NOT work with a BOSE system. According to the manufacturer and my personal experience it will not work with a BOSE...
I want to add a little extra bottom end sounds. I really do not want to use a LOC.
I am getting conflicting stories on weather this will or will not work.
Im not afraid to rewire the plug if needed. Does anybody know for sure??
2011 M3 Sport Hatch 6 Speaker - Non Bose...
I installed an AOEM-MAZ2 to add an amplifier to my system. Prior to the radio turning on there is a buzz, hum that comes through the speakers (sounds like a CD initializing) and I wanted to know if anyone else noticed this with their AOEM-MAZ2 installs.
The following is how to remove the factory receiver and install a PAC Audio AOEM-MAZ2 which gives you 2 sets of RCA outputs to connect amplified speakers or whatever you desire.
Time required: 20-30 minutes
1x small flat head screwdriver
1x #2 Phillips head screwdriver
Does anyone know for sure whether the RCA outputs on this modules are before the amp, or after the amp has processed the original signal?
I don't want to use a crummy signal from the BOSE amp to feed my amp, so I was hoping someone would know if this modules outputs the original signal from the...