2004 to 2020 Mazda 3 Forum and Mazdaspeed 3 Forums banner

adjust

  1. How to adjust windshield washer nozzle?

    2014-2018 Mazda 3 Skyactiv Discussion
    Hello everyone, I have a 2016 Mazda 3 and the passenger side windshield washer nozzle is kept spraying the washer fluid up to my roof. This really bothers me. Anyone know how to fix that? Thanks.
  2. Adjust wiper delay?

    2014-2018 Mazda 3 Skyactiv Discussion
    Curious if anyone has tried to adjust the delay at which the front wiper goes after you mist windshield fluid? In my case the wipers always start moving before any fluid hits the windshield and this has led the wipers to leave tiny scratches from dirt and such dry wiping. I have a '15 GS. Anyone...
  3. Possible to adjust dimmed display?

    2014-2018 Mazda 3 Skyactiv Audio & Electronics
    Hi all, The Mazda's new to me and my biggest gripe with it so far is the brightness level of the gauges/infotainment screen when you have the main lights on dip. The car automatically assumes you are driving at night, as all do, and lowers the brightness level, however the issue that arises is...
  4. 2016 non-Bose - any way to adjust built-in EQ

    2014-2018 Mazda 3 Skyactiv Audio & Electronics
    Hi folks, I have a 2016 6 (non-Bose) - figure there are more infotainment system peeps on here than on the 6 forum. I noticed when checking the frequency response with my Rockford Fosgate 360.3 (electrical signal, not acoustic), it is not flat. Particularly, there is a sharp drop-off in low...
  5. How-To: Adjust Foglight Height

    2014-2018 Mazda 3 Skyactiv How-To Guides
    If you are like me, the original foglight height was too low for my taste, could also be because of the way the bowls reflect HID bulbs, but i decided to adjust the higher. Just in case anyone is wondering bulb size is H11, wasn't able to find it anywhere else. 1. Remove foglight bezel 2...
  6. How to adjust headlight 2013 Mazda 3 Non HID

    2010-2013 Mazda 3 & Skyactiv How-To Guides
    Picture borrowed from another user's post "Mike". Use a Phillips screwdriver and look down at the green circle, you'll see a gear like screw. Insert Phillips screwdriver, turn clockwise to raise head lights and counter clockwise to lower head lights (to keep them even you can count the...
  7. How to adjust door holder?

    2004-2009 Mazda3Appearance & Interior
    Mazda 3, 2008 model. I have just put on a replacement door (passenger side, rear). Everything is fine except the 'door holder' (the little bar that stops the door opening too far). 1) the bar doesnt stick out far enough 2) the hole on the bar is smaller than the original, so the bolt I have...
  8. Adjust handbrake

    2010-2013 Mazda 3 & Skyactiv How-To Guides
    As anyone done this allready? I know how to take the plastic trim (basicly pull up the piece) is then, near the handbrake, some bolt to tight the brake? it is holding only higher and higher the other day even let it a bit loose and the car moved itself :blush 1: thank God no damages
  9. Adjust Project Inward/Outward?

    2010-2013 Mazda 3 & Skyactiv Appearance & Interior
    Adjust Projector Inward/Outward? I've been searching the threads on every site and googled at least 100 variations of my question and no answers.:no: I recently had the body shop to some work on the front end of my car. When I got it back, the cut off of the beam from the projector headlights...
  10. 2010 Mazda 3 headlights adjust

    2010-2013 Mazda 3 & Skyactiv Discussion
    I have the 2010 Mazda 3 GT with AFS. Can anyone tell me what this one adjust in the picture circle in red below. Is this one to adjust horizontal aiming because I know the bigger adjuster on the bottom is for vertical aiming.
Top